Textiles in Pakistan. Approximate location 24.84206, 67.21181.
TextilesPakistanCO₂ reported
Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 is a textile mill in Pakistan with a reported capacity of 20,148,964 USD. It spins, dyes and finishes textiles, leather or apparel using process steam. By capacity it ranks #134 of 151 textile mills tracked in Pakistan. It emits about 441 tonnes of CO₂e per year (Climate TRACE) — roughly the tailpipe emissions of 103 cars.
Facility data: Climate TRACE v6 (asset-level capacity & CO₂e, CC BY 4.0), id ct-38475057.
При потужності 20,148,964 USD Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 — це приблизно медіана textile mill у Pakistan (20,148,964 USD). Підсектор: textiles-leather-apparel. Як textile mill, воно вимагає високотемпературного технологічного тепла (зазвичай 60–150°C) для основних промислових операцій — тепла, яке повинне подаватися котлами, печами або прямим спаленням, і втрати через неізольовані судини та трубопроводи представляють витрачене напразно паливо. Знімна модульна теплоізоляція може зменшити ці втрати на 80–96%, охолодивши поверхню обладнання до ≤45°C, з окупністю часто менше 2 років. Текстильні фабрики використовують технологічну пару для фарбування, обробки та сушки, часто потребуючи суворого контролю температури протягом тривалих циклів — постійні втрати тепла знижують прибутковість.
Порівняння продуктивності та інтенсивності CO₂ розраховано на основі даних промислових об'єктів Climate TRACE; роль сектору заснована на інженерних довідниках.
This facility's reported annual CO₂e in the everyday equivalents from the US EPA Greenhouse Gas Equivalencies calculator:
Equivalencies: US EPA Greenhouse Gas Equivalencies. Emissions: Climate TRACE.
Reported capacity (USD), Climate TRACE v6 (asset-level capacity & CO₂e, CC BY 4.0).
Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 sits in a hot desert climate zone (Köppen BWh), at 24.8°N in the northern hemisphere.
Köppen zone: Köppen-Geiger world climate classification (Kottek et al. 2006, 0.5° grid).
The #134 largest of 151 textile mills in Pakistan by reported capacity.
Coordinates 24.84206, 67.21181. View on OpenStreetMap.
A textile mill like this runs hot equipment that sheds heat continuously: dyeing vessels, stenters/dryers, steam lines, hot-water & boiler house (surface/process temperatures around 80–200 °C). These surfaces lose energy to the air year-round; removable modular insulation cuts that loss, brings outer surfaces to ≤45 °C, and unclips for inspection.
effectively industrial laundries/dyeing - steam & hot water; 500-3000 MWh typical.
On an already-insulated site (pipes & valves in cladding / jackets), closing the remaining gaps, flanges and damaged sections and switching to removable covers indicatively recovers about 550 MWh/yr (≈ 110 t CO₂/yr) — scaled to this site's reported CO₂ within its sector. Bare or damaged surfaces recover several times more.
See Inzonex insulation → Estimate your site →
Indicative, not a measurement. Conservative floor for an already-insulated plant; a TIPCHECK on-site audit gives a measured figure. Industry context: EiiF TIPCHECK — industrial insulation can save ~14 Mtoe/yr in EU, payback typically <2 years.
Bare hot surfaces here exceed the touch-safe limit (EN ISO 13732-1); insulation to ≤45 °C is a worker-safety and compliance win. And before electrification, fuel-switching or CCS, eliminating surface heat loss is the cheapest, fastest, lowest-risk step — audit the bare spots first, rip-and-replace later.
Domestic energy-efficiency grants are limited here; industrial decarbonisation is mainly funded externally:
CBAM. Exporters of cement, steel, aluminium, fertiliser, hydrogen and electricity to the EU face the Carbon Border Adjustment Mechanism — cutting embedded emissions (efficiency + insulation) lowers the levy.
Routed via national development banks / accredited entities — not a direct factory grant. Verified 2026.
Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 is a textile mill in Pakistan. It spins, dyes and finishes textiles, leather or apparel using process steam.
Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 has a reported capacity of 20,148,964 USD.
Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 emits about 441 tonnes of CO₂e per year (Climate TRACE) — roughly the tailpipe emissions of 103 cars. That ranks #115 among tracked facilities in Pakistan.
Al-Karam Textile Mills (Pvt.) Ltd. Unit 2 is in Pakistan, near coordinates 24.84206, 67.21181.
